Muestras de PCB

Ejemplos de PCB

Five PCB examples, with the materials, stack-ups and fabrication decisions behind them.

PCB for a base-station power amplifier

Special processes follow the application

For communications and RF equipment, a design may need a hybrid stack-up, controlled impedance and back drilling. A power electronics board may instead call for heavier copper, a metal base or embedded copper. A flexible circuit for imaging or a sensor assembly may use a stiffener or shielding film only where the mechanical design calls for it.

The examples cover boards for communications, servers, automotive electronics, industrial control, imaging and medical electronics. These applications help frame the engineering questions. For example, a server board may need a low-loss laminate and a carefully defined via structure, while an industrial connector can depend on how rigid and flexible layers are joined.

Five board examples and the decisions behind them

Hybrid lamination and back drilling

77 GHz radar PCB

The 18-layer sample combines TSM-DS3, FR28 prepreg and S1000-2M. Its blind and buried vias, ENIG finish and five back-drill groups make the drill plan as important as the laminate selection. Each drill group needs a defined layer target.

Más información
Low-loss material and blind vias

High-speed server PCB

This 18-layer MEGTRON 8 board is 3.1 mm thick, with a 0.15 mm minimum hole and full-board hard gold. The combination of blind vias, board thickness and finish needs to be confirmed as one fabrication scope.

Más información
4R + 4F + 4R stack-up

Rigid-flex PCB for an industrial connector

The 12-layer sample combines ITEQ IT-180 and DuPont AP9141R and has a finished thickness of 1.6 mm. The stack-up identifies how the four flexible layers run between the rigid sections, so the transition can be reviewed before lamination.

Más información
RT5880 and laser profiling

Millimeter-wave antenna PCB

The eight-layer sample uses Rogers RT5880, a 3 µm soft-gold finish and laser profiling. The drawing needs to carry both the finish requirement and the agreed outline, alongside the material and layer construction.

Más información
Hybrid board with an embedded copper section

5G base-station power amplifier PCB

This four-layer design combines RO4350B and FR-4 with blind vias, a stepped cavity and a partially embedded copper block. The drawing needs to locate the cavity and copper block relative to the surrounding layers and drilled features.

Más información

Envíe sus requisitos de PCB y materiales

  • Revisión de producto, compras y producción antes de cotizar
  • Cantidades y requisitos separados para prototipo y serie
  • Inspección, documentos y entrega acordados por pedido