Industrial Support · Production

PCB Surface Finishes for Solder Pads and Contacts

Choose ENIG, HASL, OSP or selective plating according to assembly, contact and storage requirements.

ENIG / HASL / OSP etc.
Panel with gold surface finish

Mark the finish by location

Fine-pitch assembly can require flatter pads. Sliding or mated contacts may require a different finish. Show gold fingers and selective plating boundaries on the fabrication drawing.

State the finished condition to inspect

Specify the assembly process, storage needs and any coating thickness or measurement locations. Agree on which finish applies to each region before release.

  • Assembly process and component types
  • Flatness needs
  • Shelf life and storage
  • Selective finish requirements

Surface finishes by board type

ParameterPrototypeMass production
Rigid — Surface finishENIG, electrolytic gold, HASL, Ni/Pd/Au, thick electrolytic gold, immersion tin, immersion silver, OSP, carbonENIG, electrolytic gold, HASL, Ni/Pd/Au, thick electrolytic gold, immersion tin, immersion silver, OSP, carbon
Rigid-flex — Surface finishENIG, electrolytic gold, HASL, Ni/Pd/Au, thick electrolytic gold, immersion tin, immersion silver, OSP, carbonENIG, electrolytic gold, HASL, Ni/Pd/Au, thick electrolytic gold, immersion tin, immersion silver, OSP
FPC — Surface finishHASL, ENIG, immersion silver, OSP, Ni/Pd/Au, electrolytic goldHASL, ENIG, immersion silver, OSP, Ni/Pd/Au, electrolytic gold

Prototype and mass-production values are listed separately and are not interchangeable. Every value is confirmed against your files, the selected material and the assigned facility during engineering review.

Typical applications

Fine-pitch assembly

Wire bonding and contacts

General-purpose boards

Surface Finishing FAQs

Which finish should I choose?

It depends on components, assembly and application. Engineering can advise.

Can one board use two finishes?

Selective finishes are reviewed per design.

Start your OEM or EMS project

  • Review of product, sourcing and production requirements before quotation
  • Separate quantities and requirements for prototype and production
  • Inspection, documents and delivery agreed for the order