Advanced PCB · Advanced Materials

PTFE Laminates for RF PCBs

Review PTFE grades and hybrid stacks by frequency, dielectric thickness, via construction and finished outline.

RF / microwave
Round PTFE RF board

Identify where PTFE is needed

Specify frequency, material grade and dielectric targets. Mark whether PTFE applies to the whole board or selected RF layers, and identify material interfaces on the stack-up.

Specify the results that must be measured

Give critical hole groups, outline tolerances, impedance targets and the required reports. Check process compatibility against the complete laminated structure.

  • PTFE material type
  • Hole preparation and plating
  • Hybrid constructions
  • Finish selection

Typical applications

Microwave circuits

Radar and sensing

Satellite communication

What to send

Helpful details for advanced designs

  • Target frequency, data rate and loss budget
  • Impedance targets and tolerances
  • Preferred or approved materials
  • Via structure and back drilling layers
  • Test and inspection requirements

Start a project

Send your files and planned quantities. We will confirm the open engineering points before quoting.

PTFE FAQs

Is PTFE harder to process?

It needs specific processing steps, which are reviewed during engineering review.

Can PTFE be combined with FR-4?

Hybrid constructions are reviewed per project.

Send your PCB and material requirements

  • Review of product, sourcing and production requirements before quotation
  • Separate quantities and requirements for prototype and production
  • Inspection, documents and delivery agreed for the order