PCB Manufacturing · Standard & Advanced PCB

Flexible PCB and FPC Fabrication

Specify installation folds or repeated motion, with bend locations, coverlay openings, connector regions and stiffeners.

Flexible circuits
Flexible printed circuit

Document the movement before selecting the construction

A one-time assembly fold needs a bend location and direction. A dynamic application needs its intended radius, travel and verification conditions. Locate stiffeners and transitions relative to the bending region.

Use the FPC capability table

Published minimum trace and space are 40 µm each for FPC prototypes and 35 µm each for production. Confirm the applicable combination of copper, thickness, coverlay and profile tolerance.

  • Flexible material and copper choice
  • Coverlay openings and stiffeners
  • Static or dynamic bend requirements
  • Connector and termination areas

Flexible circuit capability

Flexible PCB (FPC) capability
ParameterPrototypeMass production
Layer count (max)1216
Min dielectric thickness12.5 µm12.5 µm
Min BGA pitch150 µm100 µm
Min board thickness50 µm50 µm
Max panel size610 × 1200 mm610 × 1200 mm
Base copper thickness9–35 µm6–35 µm
Min trace / space40 / 40 µm35 / 35 µm
Pattern registration tolerance±50 µm±20 µm
Min pattern-to-edge clearance0.10 mm0.07 mm
Etching tolerance±20 µm±15 µm
Min through-hole diameter0.10 mm0.075 mm
Min blind via diameter0.05 mm0.05 mm
Hole position tolerance±0.05 mm±0.05 mm
Impedance control tolerance±10%±5%
Outline tolerance±0.10 mm±0.05 mm
Surface finishHASL, ENIG, immersion silver, OSP, Ni/Pd/Au, electrolytic goldHASL, ENIG, immersion silver, OSP, Ni/Pd/Au, electrolytic gold
Stiffener typeFR-4, PI, stainless steelFR-4, PI, stainless steel
Stiffener registration tolerance±0.20 mm±0.10 mm
HDI capability4-layer any-layer interconnect6-layer any-layer interconnect
LCP materialSupportedSupported

Prototype and mass-production values are listed separately and are not interchangeable. Every value is confirmed against your files, the selected material and the assigned facility during engineering review.

Typical applications

Display and camera connections

Wearables and hand-held devices

Battery and sensor interconnects

What to send for a PCB review

Start with the details you have — engineering will request anything else needed for the review.

Files and details for a PCB review

  • Gerber (RS-274X) or ODB++ data with drill files
  • Fabrication drawing with material, thickness and finish
  • Stack-up and impedance targets, if any
  • Quantity for prototype and for production
  • Special requirements such as IPC class, testing or packaging

Technical files stay private

Gerber files, BOMs and drawings are handled privately and shared within your project.

Flexible PCB (FPC) FAQs

What is the difference between static and dynamic flexing?

Static flex bends once during installation; dynamic flex moves repeatedly in use. Tell us which applies so the construction can be reviewed accordingly.

Can you add stiffeners?

Stiffener material and placement are reviewed per design and confirmed in the quotation.

Send your PCB and material requirements

  • Review of product, sourcing and production requirements before quotation
  • Separate quantities and requirements for prototype and production
  • Inspection, documents and delivery agreed for the order